UPDATE: After another reboot (3 of them) everything started working again!
ypwlng
New Member
Hi - I would like to have my PELCO-D camera and VISCA (UART) camera on the same serial RS485 bus, let's call it COM1. Does PTZ-Controls separately try to open COM1 for PELCO-D and VISCA, or will it open COM1 once and send either instruction depending on which camera? The reason I ask is if I change the baud rate on the settings on the PELCO COM1 it doesn't show the same on the VISCA COM1.
Today I updated OBS from v31.0 to v32.1.2
I installed the latest version of PTZ Controls and now each time I start OBS (Windows 11), I get the following popup dialog:
"The following OBS plugins failed to load: obs-ptz - Please update or remove these plugins."
Problem is, the plugin loads and works just fine. All the controls work, it's listed under Docks just fine, and in the new Plugin Manager, it's listed and a check mark is next to it showing it's active.
Disabling it, restarting OBS, re-enabling it, rebooting, re-installing, etc... has no impact. OBS still pops that dialog at startup, even though everything is fine.
Any ideas?
I installed the latest version of PTZ Controls and now each time I start OBS (Windows 11), I get the following popup dialog:
"The following OBS plugins failed to load: obs-ptz - Please update or remove these plugins."
Problem is, the plugin loads and works just fine. All the controls work, it's listed under Docks just fine, and in the new Plugin Manager, it's listed and a check mark is next to it showing it's active.
Disabling it, restarting OBS, re-enabling it, rebooting, re-installing, etc... has no impact. OBS still pops that dialog at startup, even though everything is fine.
Any ideas?